Mitsubishi Electric MELSEC-Q Series User Manual page 107

(1) Setting method
(a) Input status of data link faulty station
Set this item in the "Network Operation Settings" window. (Refer to Section 7.5.)
(b) Cyclic data output when a stop error occurs in the CPU module
Select "PLC Parameter" and set it in "Intelligent Function Module Detailed Setting".
[Project Window]
[Detailed Setting] button
(2) Precautions
(a) When data link is stopped by users
When cyclic transmission is stopped using one of the following methods, the input
status of the faulty station is held.
• CC-Link IE Field Network diagnostics (Refer to Section 9.4.)
• Link special relay (SB), link special register (SW) (Refer to Section 11.3.)
(b) Setting on a station with a data link error
When the following settings are set to "Hold" on the station where a data link error
has occurred, the input status of the own station upon error is held, regardless of
setting.
• "Network Operating Setting"
Section 8.3.6 (2).)
• "PLC Parameter"
Time Output Mode" (Refer to Section 8.3.5 (1) (b).)
[Parameter] [PLC Parameter]
"Error Time Output Mode"
"Output Setting During CPU STOP" (Refer to
"Intelligent Function Module Detailed Setting"
8 - 17
Chapter 8 FUNCTIONS
"I/O Assignment" tab
"Error