Mitsubishi Electric MELSEC-Q Series User Manual page 147

Device Item
Abnormal end
(S1)+0
type
Completion
(S1)+1
status
Channels used
(S1)+2
by own station
Target station's
(S1)+3
CPU type
Target station's
(S1)+4
network No.
Target station
(S1)+5
number
(S1)+6 –
Number of
(S1)+7
resends
Arrival monitoring
(S1)+8
time
(a) Control data
b15
1) Abnormal end type (bit 7)
Specify the set status of data in case of abnormal end.
0: After (S1)+11, no data is set for abnormal end.
1: After (S1)+11, data is set for abnormal end.
The status of the instruction completion is stored.
0: Normal
Other than 0: Error (Refer to Section 12.5.)
Specify the channels to be used by the own station.
(Refer to Section 10.2.2.)
Specify the CPU module on the target station to be accessed.
0000H: Control CPU (The access destination is the same as that of
when 03FFH is selected.)
03FFH: Control CPU
If the above error occurs and the instruction fails, execute the instruction
again.
Specify the network No. of the target station.
1 to 239: Network No.
254: Specify this when 254 is set for Jn.
Specify the target station number.
Master station: 125 (7DH)
Intelligent device station: 1 to 120
When 125 (7DH) is set, the module always accesses the master station
(station number 0).
Unused
During instruction execution
For the case where the instruction is not completed within the monitoring
time specified by (S1)+8, specify the number of times the instruction is
resent.
When the instruction is completed
The number of resends (result) is stored.
Specify the monitoring time until instruction completion.
If the instruction is not completed within the specified time, the instruction is
resent for the number of resends specified by (S1)+7.
0: 10 seconds
1 to 32767: 1 to 32767 seconds
Chapter 10 DEDICATED INSTRUCTIONS
Setting data
to b7 to
0 1) 0
10 - 9
Setting range
b0
1
0001H
0081H
–
1 to 2
0000H
03FFH
1 to 239
254
125 (7DH)
1 to 120
0
0 to 15
–
0 to 32767
Set by
User
System
User
User
User
User
User
User
System
User