Mitsubishi Electric MELSEC-Q Series User Manual page 64

1) Network setting
2) CC IE Field
Configuration Settings
3) Network Operation
Settings
4) Refresh Parameters
5) Interrupt Settings
6) Interlink Transmission
7) Routing Parameters
: Always
: When required
– : Cannot be set
POINT
• When parameters are not set
The Simple Motion module operates as the master station in network number 1.
In this case, only transient transmission is performed. (Cyclic transmission is not
performed.)
(2) Parameters set for slave stations (other than Simple Motion modules)
For the settings of a slave station, refer to the manual for the slave station used.
Item
Network Type
Start I/O No.
Network No.
Total Stations
Station No.
Mode
Assignment Method
Station No.
Station Type
RX/RY Setting
RWw/RWr Setting
Refresh Device
Reserved/Error Invalid Station
Alias
Comment
Link Scan Mode
Setting
Loopback Function
Supplementary Setting
setting
Block Data Assurance
per Station
Operation Setting for
Returning
Equal Assignment
Identical Point Assignment
Parameter Name
Data Link Faulty Station Setting
Output Setting During CPU STOP
Set IP address
7 - 4
Chapter 7 PARAMETER SETTING
Necessity of
setting
–
–
–
–
–
–
–
Reference
Section 7.3
Section 7.4
Section 7.5
Section 7.6
Section 7.7
–