Tele Radio T24-01 Installation Instructions Manual page 92

Installation instructions│ T24│ Annex A: List of errors and error messages
Event code
RepeaterConfigrationEnterSuccessful
(1392)
RepeaterConfigurationExit (1393)
RepeaterConfigurationTimedOut (1394)
RepeaterConfigurationSet (1395)
RepeaterConfigurationErrorNoRxAvailable
(1396)
RepeaterConfigurationErrorConfigIdIsZero
(1397)
DisplayBoardFatalCapSensorError (1398)
DisplayBoardRestartDetected (1399)
DisplayBoardRestartFailed (1400)
EnableWifiFromCPU3 (1401)
DisableWifiFromCPU3 (1402)
BlobStartupFailure (1403)
92
Even description
[ Repeater (rptId = xxxx)
replied and has entered
configuration mode ]
[ CPU3 initiated repeater
config exit: saveSettings =
xxxx ]
[ Repeater configuration
timed out. No repeater
replied within timeout ]
[ CPU3 updated the repeater
configuration: rptSlotID =
xxxx. Will be sent to the
repeater under configuration.
]
[ Tried to start repeater
configuration, but there are
no RX stored in the
transmitter ]
[ Tried to start repeater
configuration, but configId
is zero which we do not allow
]
[ Display board (TR403)
reports fatal CAP sensor
error ]
[ Display board has restarted
]
[ Display board has failed to
re-establish communication
after restart ]
[ CPU3 enables WiFi ]
[ CPU3 disables WiFi ]
[ CPU3, fatal BLOB error
during start, error code
xxxx]
Category
3
3
3
3
3
3
1
1
1
3
3
1
IM-PM-TX101-EN-v08