Tele Radio T24-01 Installation Instructions Manual page 57

Installation instructions│ T24│ Chapter 9: Configuration menu
9.7 C l ear b l o c k ed in p u t s
On start up, the T24 transmitters perform a zero position check for control
switches, joysticks and/or paddles.
If the transmitter detects that some control
commands are not in the zero position, the
following warning message is displayed:
If the affected controls are not released, the
transmitter will block the corresponding inputs
and display the error message:
The next time the transmitter is started, the
display will show the warning message:
To clear the locked inputs:
1. Make sure that the Stop button is pressed.
2. Twist and release the Stop button.
The initial start-up logo is displayed. Battery indicator(s) light(s). The
display shows:
3. Enter Menu mode (see
4. Navigate to the
5. Press the Select button to enter.
The display shows:
6. Press the Up or Down button to change
7. Press the Select button to confirm.
The display returns to the menu list.
If successfully completed, at next start-up:
l
The display shows:
If not successfully completed, at next start up:
l
The display shows:
[IO board 0X: 0xXXXXXXXX]
Go back to step 1 and try again.
IM-PM-TX101-EN-v08
[Session Selection]
"9.2 Enter Menu mode (no PIN code required)
[Clear blocked input]
[Value: False]
[Session Selection]
[Inputs have been blocked.]
.
[One or more inputs are not
in the zero/startup position]
[Release all controls to
proceed.]
[Zero position problem
identification in progress.]
[Please wait for device to
automatically restart]
[Inputs have been blocked.]
[IO board 0X: 0xXXXXXXXX]
menu using the Up/Down buttons.
to .
[False] [True]
.
").
57