Tele Radio T24-01 Installation Instructions Manual page 45

The display shows:
receivers. Selected receivers are marked with a + sign.
If the correct receiver is already selected
Press the Back button.
l
The display shows:
Proceed to step 10.
l
To select/change receiver(s):
Proceed to next step.
l
6. Choose the receiver(s) to operate using the Up/Down buttons.
7. Press the Select button to select.
A + sign is displayed in front of the selected receiver.
8. Repeat step(s) 6–7 if necessary.
9. Press the Back button to accept.
The display shows:
10. Press and hold both Start buttons simultaneously for one second.
The buzzer emits a beep.
11. Release both Start buttons.
The Status LED flashes rapidly while waiting for the receiver confirmation.
If the transmitter has already been logged in to the receiver:
l
The display shows:
The transmitter logs in to the receiver in which it has been
registered in. The Status LED lights green.
If the transmitter has not been logged in to the receiver:
l
The display shows:
session.]
Start the transmitter again and log in to a receiver before
proceeding with the start-up procedure
transmitter in to a
NOTE: If the paired receiver is not detected within 30 s, the login process is
canceled. The display shows:
and the transmitter turns off.
xxxx]
12. Proceed with the functional test (see
IM-PM-TX101-EN-v08
Installation instructions│ T24│ Chapter 8: Operation
[Select one or more items]
[Session Selection]
[Session Selection]
[Logging in...]
[Login failed. No receivers selected for
The transmitter turns off.
receiver").
[Login failed. Timout. Receiver HY-RX-
"8.4 Functionality
and the list of registered
("8.5 Log the
test").
45