Installation instructions│ T24│ Chapter 9: Configuration menu
9.1 3 Regis t er RF ID t ags
NOTE: If the RFID functions are not activated, contact your representative for
assistance.
1. Make sure that the Stop button is pressed.
2. Twist and release the Stop button.
The initial start-up logo is displayed. Battery indicator(s) light(s). The
display shows:
3. Enter Menu mode (see
4. Navigate to the
Up/Down buttons.
5. Press the Select button to enter.
The display shows:
registered RFID tags' ID numbers.
6. Choose a location for the RFID tag to be registered in using the Up/Down
buttons.
7. Press the Select button to select.
A + sign is displayed in front of the selected location.
8. Press the Back button to accept.
The display shows:
9. Place the RFID tag against the RFID symbol located under the transmitter
housing, next to battery compartment 1.
If successfully completed:
l
The buzzer emits 3 short beeps. The display returns to the menu list.
If no tag is presented within 20 s:
l
The transmitter turns off.
IM-PM-TX101-EN-v08
[Session Selection]
"9.2 Enter Menu mode (no PIN code required)
[Startup Protection – RFID Learn]
[Select a single item]
[Waiting for a valid tag to be presented...]
menu using the
and the list showing the
").
63