Tele Radio T24-01 Installation Instructions Manual page 66

Installation instructions│ T24│ Chapter 9: Configuration menu
9.1 5 C o n f igu re rep eat er s l o t ID
The slot ID corresponds to the position of a repeater in a chain of one to up to
fifteen repeaters (0–14). By default, the first repeater in the chain will take slot ID 0.
IMPORTANT! To be able to communicate with each other, the repeater, the
receiver and the transmitter must have the same configuration ID. The
configuration ID is set in SM (V or higher).
IMPORTANT! It is strongly recommended to have only one repeater powered up
and in range of the transmitter when performing configuration via radio.
NOTE: The transmitter must be registered in a receiver for the repeater
configuration procedure to be successful. If the transmitter is not registered in a
receiver, the display will show:
start the repeater config]
Register the transmitter in the receiver (see
receiver") before proceeding with the configure repeater instruction.
1. Make sure that the Stop button is pressed.
2. Twist and release the Stop button.
The initial start-up logo is displayed. Battery indicator(s) light(s). The
display shows:
3. Enter Menu mode (see
4. Navigate to the
buttons.
5. Press the Select button to enter.
The display shows:
wait...]
6. Place the repeater within 1 m from the transmitter or quickly tap the
repeater's function button five times to put it in configuration mode.
If a repeater responds within 30 s:
The display shows:
Configuration]
66
[No RX are registered in this TX. Cannot
.
[Session Selection]
"9.2 Enter Menu mode (no PIN code required)
[Repeater Configuration]
[Searching for repeater within range. Please
[Repeater
highlighted in black.
"9.4 Register a transmitter in a
menu using the Up/Down
If no repeater has responded within
30 s:
The display shows:
[Got timeout
while polling for repeater]
IM-PM-TX101-EN-v08
").