Tele Radio T24-01 Installation Instructions Manual page 51

Installation instructions│ T24│ Chapter 9: Configuration menu
9 . 3 . 2 S O F T W A RE V E RS I O N S W 0 0 3 3 -1 1 V 0 9 O R L O W E R
1. Make sure that the Stop button is pressed.
2. Twist and release the Stop button.
The initial start-up logo is displayed. Battery indicator(s) light(s). The
display shows:
3. Press and hold side button SBX2 (middle button on the right side of the
transmitter).
4. Press the Stop button.
5. Release side button SBX2.
The display shows:
6. Enter the first digit using the Up/Down buttons.
NOTE: Once the Select button has been pressed, it is not possible to move
back to the previous digit. Pressing the Back button will abort the
procedure.
7. Press the Select button to accept and move to the next digit.
8. Repeat steps 6–7 until all four digits have been entered.
9. Press the Back button to accept.
If the entered PIN code is correct:
l
The display returns to the menu list.
If the entered PIN code is incorrect:
l
The display shows:
shutting down device]
Go back to step 1 and try again.
IM-PM-TX101-EN-v08
[Session Selection]
[Config Menu PIN 0000]
[Config Menu PIN Incorrect PIN entered,
. The transmitter turns off.
51