Tele Radio T24-01 Installation Instructions Manual page 48

Installation instructions│ T24│ Chapter 9: Configuration menu
CHAP TER 9 : CO NFIG URATIO N M ENU
9.1 M en u m o de an d s t an dard s et t in gs
The Menu mode allows for certain settings to be set directly from the transmitter.
Once in Menu mode, the following menus will be available.
Menu
–
[Register
–
[Erase]
–
[Replace]
–
[Clear blocked
input]
–
[Radio Channel]
–
[Backlight
Intensity]
–
[Buzzer Volume]
–
[Radio Inactivity
Timeout]
–
[Time Zone]
–
[Startup protection
– RFID Learn]
–
[Startup protection
– RFID Erase]
–
[Repeater
Configuration]
–
[Show device
information]
–
[Show BLOB info]
–
[Start RFID Test]
For more information about the menu navigation, see
48
Description
Select a location to register a new receiver in. Radio
communication is immediately enabled when the
registration is confirmed.
Select a registered receiver to be erased from the
transmitter.
Select a registered receiver to be replaced.
Reset any blocked input.
Select the channel/bank to use.
Set the display luminosity (in %).
Set the buzzer volume level (in %).
Set the off delay ( in s) before the transmitter
automatically switches off.
Select the time zone (UTC +/- 14 h).
Register one or more RFID tags in the transmitter for
start up protection.
Erase one or more registered RFID tag from the
transmitter.
Set the position number of a repeater (slot ID) when
used in a chain of repeaters.
Display the unit's serial number and a list of the
software versions currently installed on the
transmitter.
Display BLOB information.
For testing the registered RFID tags.
"8.2 General navigation".
IM-PM-TX101-EN-v08