Tele Radio T24-01 Installation Instructions Manual page 81

Installation instructions│ T24│ Annex A: List of errors and error messages
Event code
CapSensorEnteringAtiDuringInit (1051)
CapSensorEnteringAtiSpontaneously (1052)
CapSensorLeavingATI (1053)
CapSensorAtiError (1054)
CapSensorChangeOneElectrode (1055)
CapSensorFailedReadingSysFlags (1056)
CapSensorFailedReadingCountsReg (1057)
CapSensorRequestingPowerReset (1058)
ChargerConnected (1070)
ChargerDisconnected (1071)
ChargerBatteryActivation (1072)
IM-PM-TX101-EN-v08
Event description
[ Cap sensor entering ATI
during init, sensor index:
xxxx ]
[ Cap sensor entering ATI
spontaneously, sensor index:
xxxx ]
[ Cap sensor leaving ATI,
sensor index: xxxx ]
[ Cap sensor index: xxxx
failed to complete ATI
procedure ]
[ Change of cap sensor value,
sensor: xxxx electrod: xxxx,
relative change: xxxx change:
xxxx, capSensorCountRegsFast:
xxxx, capSensorCountRegsSlow:
xxxx ]
[ Failed to read IQS263_SYS_
FLAGS_REG from capacitive
sensor xxxx, got xxxx from
i2cOperation() ]
[ Failed to read IQS263_
COUNTS_REG from capacitive
sensor xxxx, got xxxx from
i2cOperation() ]
[ Communication lost to one
or more CAP-sensors (xxxxxx
xxxxxx xxxxxx xxxxxx xxxxxx
xxxxxx ). Requesting power
cycle of I2C bus and slaves ]
[ A charger is connected to
the cable-control connector ]
[ Charger was disconnected
from the cable-control
connector ]
[ Performing battery
activation ]
Category
1
1
1
1
1
1
1
1
3
3
2
81