Tele Radio T24-01 Installation Instructions Manual page 47

8 .9 A dvan c ed o p erat io n
8 . 9 . 1 P I T C H & C A T C H
NOTE: For this procedure to succeed, the Pitch & Catch function must have been
configured in the receiver and in the transmitter(s) allowed to carry out Pitch and
Catch. Contact your representative for assistance
NOTE: For this procedure to succeed, the transmitters must be set to the same
radio channel.
The transmitter being in an ongoing session must allow (pitch) the other
transmitter to take over (catch) the session.
On the transmitter in session
1. Press and hold the
allowPitchAndCatchProcedureButton
button.
The transmitter enters Picht&Catch
mode.
3. Once the other transmitter has
successfully logged in, release the
allowPitchAndCatchProcedureButton
button.
4. Press the Stop button.
8 . 9 . 2 M A S T E R T A K E O V E R
NOTE: For this procedure to succeed, the Master takeover function must have
been configured in the receiver and in the transmitter(s) allowed to carry out
Master takeover . Contact your representative for assistance
NOTE: Once Master takeover has been configured, it is possible to log in with any
master transmitter even if someone else has logged in before, or even when there
is no session active.
1. Log in with the Master transmitter.
Any other transmitter in session is automatically logged out.
The transmitter is logged in to the receiver.
IM-PM-TX101-EN-v08
Installation instructions│ T24│ Chapter 8: Operation
On the transmitter that will "catch" the
2. Log the transmitter in the
session
receiver.
The transmitter has taken over
the session.
47