JMA AVANTCODE User Manual page 63

6.2 REPLACING THE FUSES
If the machine fails to start when switched on, check the fuses. The machine has two fuses: one
is located in the back and the other in the machine control board. Follow these steps to change
the fuse:
1. Turn off the machine off at the main switch and disconnect the power cable.
Rear fuse:
1. Remove the fuse holder beneath the main switch on the back of the machine (Fig.41)
2. Use a tester to check whether the fuse has blown, and if necessary replace it with an
identical fuse. F6A 250V.
(NB: The spare fuses is in the switch general)
Control board fuse:
1. Release the screws on the machine's lower casing.
2. Remove the fuse from the control board and check whether it has blown, if so,
replace it with an identical fuse: T4A 250V (Fig.42)
(NB: The accessory box comes complete with spare fuses)
Fig.41
Fig.42
57