Combination P1: Edit-Program/Mixer; 1-1: Program/Mixer - Korg Triton Studio Parameter Manual

0–5b: Sampling Setup
Source BUS
Trigger [Sampling START SW, Note On]
Metronome Precount
Save to
Mode (Sample Mode)
Sample Time
Make settings for sampling in Combination mode. ( Pro-
gram P0: 0–3)
Sampling Setup settings apply to the entire Combination
mode; not to an individual combination.
0–5c: Recording Level [dB]
ADC OVERLOAD !!
Recording Level [–inf, –72.0... 0.0...+18.0dB]
Adjusts the signal level at the final stage of sampling in
Combination mode. ( Sampling P0: 0–1d)
This setting defaults to –12 dB when you turn on the power.
At a setting of –12 dB, CLIP will not appear even if you play
the Combinetion at its maximum level.
( Program P0: 0–3c "Recording Level")
M 0–5: Page Menu Command
0–1A: Write Combination, 0–1B: Solo Selected Timbre,
Program P0: 0–3A: Metronome Setup,
Program P0: 0–3B: Optimize RAM,
Program P0: 0–3C: Select Bank & Smpl No.,
Program P0: 0–3D: Select Directory
[L/R, Indiv.1/2]
[Off, 4, 8, 3, 6]
[RAM, DISK]
[L-Mono, R-Mono, Stereo]
[min sec]
Combination P1: Edit–Program/Mixer
1–1: Program/Mixer
For each timbre 1–8, set the bank, program, pan and volume.
1–1a
1–1b
1–1a: Combination Name,
Selected Timbre Information
Combination Name
This shows the combination bank, number, and name
selected in Combination P0: Play.
Selected Timbre Information
Displays information about the selected timbre (1–8). ( P0:
0–1b)
1–1b: Timbre Number, Category, Program Select,
Pan, Volume
Timbre Number
Category
Bank/Program (Program Select)
[INT-A...INT-F, G, g(1)...g(9), g(d), EXB-A...EXB-G]
Selects the program for each timbre.
These parameters can also be set from the P0: Play, Program
Select page. ( P0: 0–1c)
Pan [RND, L001...C064...R127]
Volume
Specifies the pan and volume of each timbre.
These parameters can also be set from the P0: Play, Mixer
page. ( P0: 0–2a)
0–1
(1...8)
[00...15]
[000...127]
37