Korg Triton Studio Parameter Manual page 306

Press the locations indicated by the arrows until the
unit clicks into place, so that the internal connector is
securely connected.
Apply equal pressure to both points.
4 When you have completed all of the above steps, turn on
the power and verify that the CDRW-1 has been installed
correctly. ("Checking after installation" p.287)
If the TRITON STUDIO did not recognize the CDRW-1,
you can either press strongly once again on the arrows in
step 3, or try reinstalling the CDRW-1.
Removing the CDRW-1
When you slide the [EJECT] switch located on the bottom of
the TRITON STUDIO, the CDRW-1 will be pushed out of the
TRITON STUDIO. Gently remove the CDRW-1.
Fastening the CDRW-1 firmly in place
By using the screw included with the option, you can lock
the [EJECT] switch of the TRITON STUDIO to prevent the
CDRW-1 from coming out accidentally.
Note when transporting/moving/shipping the CDRW-1
The CDRW-1 is a precision device that is vulnerable to
shock and vibration. It may be damaged if it is left in
the TRITON STUDIO during transport or shipping.
Before you transport or ship the TRITON STUDIO,
please remove the CDRW-1 and transport it in its own
packaging.
Cautions for handling
• Make sure that the unit is level when operating.
• Do not use in extremely cold or hot locations.
• Do not use in locations of high humidity.
• Do not use this unit in locations of excessive dust or
smoke.
• Do not apply strong physical shock to the unit. In
particular, the unit is highly sensitive to physical shock
during operation (either reading or writing), and must
not be jarred.
• Normally, the drive uses software ejection. Although the
CD tray can be opened by pressing the eject button, you
can also make the tray open by inserting a pointed object
(such as straightened paper clip) into the emergency
eject hole.
• Do not store the unit in high temperature or high
humidity.
• Never touch the focussing lens.
• Do not use commercially available lens cleaners.
• Do not transport the unit with a disc left in the drive.
• Do not leave the unit with the tray left open.
CD-R/RW disc handling
Please observe the following points when handling discs.
Failure to observe these points may cause problems such as
data not being written correctly, loss of recorded data, or
drive malfunction.
• Do not place discs in direct sunlight or in locations of
high temperature or high humidity.
• Do not touch the surface of the disc. Hold the disc by its
edges.
• Remove dust or dirt from the surface of the disc. Use an
air duster or cleaner to remove dust.
• Do not affix labels to the disc, or write on the disc in
locations other than specified.
• Do not use chemicals or detergent to wipe the disc.
• Do not bend or drop the disc.
Responsibility for loss of data
Korg Corporation will accept no responsibility for any
damages (direct or indirect, whether sustained by the
customer or by a third party) resulting from loss of or
damage to data written on a CD-R or CD-RW disc.
Inserting a disc
Make sure that the power of the TRITON STUDIO is turned
on.
1 Open the disc tray
Press the eject button of the CDRW-1, and the disc tray
will open.
At this time, the tray will open only halfway. Pull it out
manually until a disc can be placed in the tray.
Before using the CDRW-1 for the first time, you
must remove the pickup stopper from the disc
tray.
Eject button
295