Download Print this page

Korg Triton Studio Parameter Manual: St. Modulation Delay (stereo Modulation Delay); St. Dynamic Delay (stereo Dynamic Delay)

Music workstation/sampler.
Hide thumbs

Advertisement

046: St. Modulation Delay
(Stereo Modulation Delay)
This stereo delay uses an LFO to sweep the delay time. The
pitch also varies. You will obtain a delay sound with swell
and shimmering. You can also control the delay time using a
modulation source.
Stereo In - Stereo Out
Left
Delay
Feedback
Delay
Right
D
-mod
Response
L/R: +/+ +/–
LFO: Tri / Sine
LFO Shape
LFO Sync
Modulation Mode
a
Switches between LFO modulation control and modulation source
control
D-mod Modulation
Reversed L/R control by modulation source
Src
b
Selects the modulation source that controls delay time
Response
Sets the rate of response to the modulation source
LFO Waveform
Selects LFO Waveform
c
LFO Shape
Determines how much the LFO waveform is changed
LFO Frequency [Hz]
d
Sets the LFO speed
LFO Sync
Switches LFO reset off/on
e
Src
Selects the modulation source that resets the LFO
L LFO Phase [degree]
Sets the phase obtained when the left LFO is reset
f
R LFO Phase [degree]
Sets the phase obtained when the right LFO is reset
L Depth
Sets the depth of the left LFO modulation
g
R Depth
Sets the depth of the right LFO modulation
L Delay Time [msec]
Sets the left delay time
h
R Delay Time [msec]
Sets the right delay time
L Feedback
Sets the feedback amount of left delay
i
R Feedback
Sets the feedback amount of right delay
Wet/Dry
Sets the balance between the effect and dry sounds
j
Src
Selects the modulation source of the effect balance
Amt
Sets the modulation amount of the effect balance
b: D-mod Modulation
When the modulation source is used for control, this parameter
reverses the left and right modulation direction.
Wet / Dry
Wet / Dry
D-mod
LFO
Modulation Mode
LFO Phase
LFO, D-mod
L/R:+/+, L/R:+/–
,
Off...Tempo
0...30
Triangle, Sine
–100...+100
Fx:020
0.02...20.00Hz
Off, On
,
Off...Tempo
–180...+180
–180...+180
0...200
0...200
0.0...500.0
0.0...500.0
–100...+100
–100...+100
–Wet...–1:99, Dry, 1:99...Wet
Fx:010,
Off...Tempo
–100...+100
e: LFO Sync, e: Src,
f: L LFO Phase [degree], f: R LFO Phase [degree]
The LFO can be reset via a modulation source.
The "Src" parameter sets the modulation source that resets the
LFO. For example, you can assign Gate as a modulation source so
that the sweep always starts from the specified point.
"L LFO Phase" and "R LFO Phase" set the phase obtained when
the left and right LFOs are reset. In this way, you can create
changes in pitch sweep for the left and right channels individu-
ally.
The effect is off when a value of the modulation source spec-
ified in the "Src" parameter is 63 or smaller, and the effect is
on when the value is 64 or higher. The LFO is triggered and
reset to the "L LFO Phase" and "R LFO Phase" settings
when the value changes from 63 or smaller to 64 or higher.
047: St. Dynamic Delay
(Stereo Dynamic Delay)
This stereo delay controls the level of delay according to the
input signal level. You can use this as a ducking delay that
applies delay to the sound only when you play keys at a high
velocity or only when the volume level is low.
Stereo In - Stereo Out
Left
High Damp Low Damp
Delay
Feedback
High Damp Low Damp
Delay
Right
FB
+
Attack, Release
Envelope
Threshold
Control Target
Selects from no control, output, and feedback
a
Polarity
Reverses level control
Threshold
Sets the level to which the effect is applied
b
Offset
Sets the offset of level control
Attack
c
Sets the attack time of level control
Release
d
Sets the release time of level control
L Delay Time [msec]
e
Sets the delay time for the left channel
R Delay Time [msec]
f
Sets the delay time for the right channel
Feedback
g
Sets the feedback amount
High Damp [%]
Sets the damping amount in the high range
h
Low Damp [%]
Sets the damping amount in the low range
Spread
i
Sets the width of the stereo image of the effect sound
Wet/Dry
Sets the balance between the effect and dry sounds
Src
j
Selects the modulation source of the effect balance
Amt
Sets the modulation amount of the effect balance
Wet / Dry
Spread
Wet / Dry
Out
Control Target
None, Out, FB
+, –
0...100
0...100
1...100
1...100
0.0...680.0msec
0.0...680.0msec
–100...+100
0...100%
Fx:043
0...100%
Fx:043
–100...+100
Fx:043
Dry, 1:99...99:1, Wet
Off...Tempo
–100...+100
213

Advertisement

   Also See for Korg Triton Studio

Comments to this Manuals

Symbols: 0
Latest comments: