Set Pan And Volume For Each Track; Output; Mixer 9–16 - Korg Triton Studio Parameter Manual

0–1D: Save Template Song
This command saves the programs, the track parameters,
and the effect settings etc. as a user template song U00–15
( Sequencer P0: 0–1H).
The settings that are saved here can also be loaded in
Sequencer mode.
0–1E: Set Location
By pressing the [LOCATE] key you can move to the location
specified here ( Sequencer P0: 0–1J).
0–3: Mixer 1–8
(Mixer T01–08)
0–4: Mixer 9–16
(Mixer T09–16)
Set the pan and volume for each track (channel).
0–1a
0–1b
0–3a
0–3(4)a: Track Number, Program Category, Pan,
Volume
Track Number
Indicates the track number. ( 0–1c/2c)
Program Category
Displays part of the program category name used by the
track.
Pan [RND, L001...C064...R127]
Sets the panning for each track (channel) 1–16 ( Sequencer
P0: 0–3b).
Tracks whose "Status" (1–1a/2a) is INT or BTH can
receive MIDI control change (CC#10) to control the pan-
pot. When receiving CC#10, a value of 0 or 1 will be far
left, 64 will be center, and 127 will be far right. Tracks 1–
16 will be controlled by MIDI channels 1–16 respec-
tively.
Volume
Sets the volume of each track (channel) 1–16.
Tracks whose "Status" (1–1a/2a) is INT or BTH can
receive MIDI control change (CC#7) to control the vol-
ume. The actual volume of a track is determined by
multiplying the MIDI volume (CC#7) and expression
(CC#11) values. Tracks 1–16 will be controlled by MIDI
channels 1–16 respectively.
0–5: Preference
Here you can make settings for playing SMF files consecu-
tively, and make settings for the metronome.
0–1a
0–5a
0–5b
0–5a: Next File
0–1
Specifies whether or not the next file will be played back in
succession when the currently selected SMF finishes play-
ing.
Chain to next file
On (checked): When the currently selected file finishes play-
ing, the next file will automatically be selected.
Auto Start
On (checked): When the currently selected SMF finishes
playing, the next file will automatically begin playing. This
is valid when "Chain to next file" is checked.
0–5b: Metronome Setup
Makes settings for the metronome.
Sound
On: The metronome will sound during playback. The sound
of the metronome will be output to the bus selected by "BUS
Select."
BUS (Output) Select (BUS Select)
Specifies the output destination of the metronome sound
( Sequence P0: 0–7b).
Level
Sets the volume of the metronome.
[0...127]
0–1
[Off, On]
[Off, On]
[On, Off]
[L/R, L, R, 1, 2, 3, 4, 1/2, 3/4]
[000...127]
125