ITech IT6000C Series User Manual page 54

Error message
Eeprom Failure
Main FrameInitializeLost
Calibration Data Lost
Config Data Lost
NETWORKING...
FIBER MULTI MASTER
FIBER EXT UNLOCK
FIBER INNER UNLOCK
Exception Handling
If the instrument cannot start normally, please check and take measures by
reference to steps below.
1. In order to facilitate the transportation and protection of the fiber optic cable,
2. Check whether the power cord is correctly connected and confirm whether
3. Check whether the power in On. The power switch is under "|" On status.
the fiber optic cable required for communication between the two single units
(one master and one slave) of the 6U model is removed at the factory and
packaged separately as an accessory. Before you turn on the power of the
device, you need to connect the fiber cable as shown in the figure below,
and then perform the power-on operation.
the instrument is powered.
Copyright © Itech Electronic Co., Ltd.
Error Description
The EEPROM is damaged.
The system setting data is lost.
The factory calibration data in EE-
PROM is lost.
The latest operation state of the in-
strument is lost.
The parallel operations are abnormal
and cannot finish the networking.
Multi-master conflict
The outer ring of the fiber is not
locked.
The inner ring of the fiber is not
locked.
Getting Started
42