ITech IT6000C Series User Manual page 44

Serv-Conf
Configurable services include: MDNS, PING, Telnet-scpi, Web, VXI-11, and
Raw Socket.
How to Configure
•
IP-Conf
Take manual configuration as an example. The steps are as follows:
1. Press the composite keys [Shift]+[P-set] (System) on the front panel to
enter the system menu.
2. Rotate the knob or press the Up/Down key to select I/O and press
[Enter].
3. Press the Left/Right key to select LAN and press [Enter].
4. Press the Left/Right key to select IP-Conf and press [Enter].
5. Press the Left/Right key to select Manual and press [Enter].
6. Set the IP, Mask and the other parameters in turns, and press [Enter].
After the last parameter Socket Port is set, the system will return to the
LAN setting interface shown as below:
SYSTEM I/O CONF
Info IP-Conf
7. Press the Left/Right key to select Reset to confirm the settings of IP-
Conf.
•
Serv-Conf
1. Press the composite keys [Shift]+[P-set] (System) on the front panel to
enter the system menu.
2. Rotate the knob or press the Up/Down key to select I/O and press
[Enter].
3. Press the Left/Right key to select LAN and press [Enter].
4. Press the Left/Right key to select Serv-Conf and press [Enter].
5. Rotate the knob to select the service you want to enable and press
[Enter].
6. Rotate the knob to select whether to enable the service and press
[Enter].
– On: Indicates that the service is enabled.
– Off: Indicates that the service is disabled.
Copyright © Itech Electronic Co., Ltd.
LAN
Serv-Conf Reset
Inspection and Installation
32