ITech IT6000C Series User Manual page 75

7. Set the parameters of step 2 in the same method.
8. Set the number of list repetitions Repeat, and press [Enter] to confirm.
9. Set the End State as Normal, and press [Enter] to confirm.
10. Depending on the test requirement, choose whether to turn on the function
11. Set the currently edited List program name.
Import List Program
If you need to run the List program on the external USB flash drive, you need to
import the List program from the USB flash drive into the instrument.
The procedures are as follows:
1. Insert the USB flash drive into the front panel USB connector.
2. Press the composite keys [Shift]+[I-set] (Function) on the front panel to en-
3. Select 1. LIST: Off and press [Enter].
4. Press the Left/Right key to select Open and press [Enter].
5. Select USB and press [Enter].
6. Press the Up/Down key to select the List file.
7. Press the Left/Right key to select Load, press [Enter] to complete the im-
switch that triggers synchronization.
If you choose not to save, press [Esc] to exit the editing interface.
The format of the List file in the USB flash drive must be in .csv format and
saved in the root directory of the USB flash drive. You can refer to
Program to customize editing according to the List file template exported to
the USB flash drive.
ter the function menu.
At this point, the system will automatically read all the List files in the root di-
rectory of the USB flash drive. The interface is displayed as follows:
XXX.csv
Not-Load Load
XXX indicates the name of the List file; YY indicates the serial number of the
current List file; ZZ indicates the total number of the List file.
port, and wait for the trigger to run this List file.
At this point, the interface returns to the main interface of the system and
LIST RUN is displayed in the lower right corner.
Copyright © Itech Electronic Co., Ltd.
YY/ZZ
Power Supply Function
Export List
63