To Configure Custom Prog Led - Carrier TruVu UCXP683T Installation And Startup Manual

Troubleshooting
Color Pattern
Magenta
White 1 blink
every
second for
15 seconds

To configure custom Prog LED

You can customize the Prog LED for site-specific purposes by configuring the BACnet Analog Output (BAO)
microblock.
Open your control program in the Snap interface, select the AO microblock for the LED, and use the following
settings:
Status/Attribute
LED
TruVu™ UCXP683T
Installation and Start-up Guide
Condition
Operating system changes are
downloading
WARNING This process could
take several minutes. Do NOT
power off the controller during the
download.
The Blink button on the controller
setup Local Network tab has been
pressed
Microblock Expander number :
type Channel number
BAO 0:61
58
Message in Module
Status
N/A
N/A
I/O type Description
Special •
<=0 Normal
•
>15 On
The number of blinks equals the
Present Value.
The pulse pattern repeats after a
2-second delay
LED will blink the number of
times given in the BAO with ON
pulse 0.5 seconds and OFF pulse
0.5 seconds.
CARRIER CORPORATION ©2022
Possible Solution
No action required
No action required
All rights reserved