Troubleshooting; Mpc Open Xp Led's - Carrier i-Vu MPC Open XP IO48/816 Installation And Startup Manual

Troubleshooting

If you have problems mounting, wiring, or addressing the MPC Open XP or the expander, contact Carrier Control
Systems Support.
NOTE To help you troubleshoot, obtain a Module Status (Modstat) from the controller and review the System Error
and Warning details.

MPC Open XP LED's

The Module Status LED can display the following error codes. Verify the LED patterns by cycling power to the
controller and noting the lights and flashes.
Error
Code... Indicates...
0 The control program or
module driver has not
been downloaded.
1 A control program error Obtain a Module Status Report (Modstat) and look for error messages. See
2 The controller's
memory is full
3 A setup error
4 A system error
7 Abnormal startup
MPC Open XP
MPC Open XP IO48/816
Installation and Start-up Guide
Possible solutions
Download memory to the MPC Open XP.
the i-Vu® application or Field Assistant Help for instructions on obtaining a
Modstat.
If you cannot determine the error from the Modstat, contact Carrier Control
Systems Support.
In the i-Vu® application, reduce the amount of trend data being stored in
the controller.
Verify:
•
The address has been set on the rotary switches. See Addressing the
MPC Open XP (page 8).
• The address is unique on the network
•
DIP switches are set correctly
Obtain a Module Status Report (Modstat) and look for error messages. See
the i-Vu® application or Field Assistant Help for instructions on obtaining a
Modstat.
If you cannot determine the error from the Modstat, contact Carrier Control
Systems Support.
Obtain a Module Status Report (Modstat) and look for error messages. See
the i-Vu® application or Field Assistant Help for instructions on obtaining a
Modstat.
If you cannot determine the error from the Modstat, contact Carrier Control
Systems Support.
Carrier Proprietary and Confidential
29
Troubleshooting
CARRIER CORPORATION ©2017
All rights reserved