Bus Node Parameters - Festo CPX-FB33 Operating Instructions Manual

Parameterisation
Detailed description of the specific parameters and basic principles for application è CPX system
description CPX-SYS-....
Parameter lists of the various CPX modules è Descriptions of the modules.
8.1

Bus node parameters

Bus node parameters
Standard CPX parameters
– SCS monitoring
– SCO monitoring
– Monitoring U
OUT
– Monitoring U
VAL
– SCV monitoring
– Fail-safe
– Force mode
– System start with external parameters or
default parameters or with saved parameters.
– Diagnostic memory
Device-specific parameters
Diagnostic message filter
Undervoltage U /U
OUT VAL
– Only available for bus nodes from Rev 14.
– Displayed in the hardware configuration (HW
Config) as "Filter Alarm U
Channel alarm filter
Undervoltage U /U
OUT VAL
– Only available for bus nodes from Rev 20.
– Displayed in the hardware configuration (HW
Config) as "Filter channel alarms U
18
/U ".
off ven
/U ".
off ven
Festo — CPX(-M)-FB33/34/35/43/44/45 — 2022-05f
Description/setting options
Standard CPX parameters – for further informa-
tion è CPX system description CPX-SYS-...
Note
The parameters of the diagnostic memory can
only be set via the CPX-MMI or CPX-FMT.
– Inactive:
Undervoltage is reported via the network
– Active:
Undervoltage messages are filtered and not
reported over the network è the under-
voltage is only indicated by the flashing SF
LED on the bus node.
– Inactive:
Undervoltage is reported via the network.
– Active:
Undervoltage messages are filtered è a max-
imum of one message per module is sent over
the network; the undervoltage is additionally
displayed by the flashing SF LED on the bus
node.