Modifying Operating Parameters - Festo Checkbox Series Manual

6. Testing parts with the Checkbox

6.3.4 Modifying operating parameters

6-18
As soon as the last good part reaches the deliveryy position
for foreign/bad parts, the counting process is finished. In
order to start a new counting process, the Checkbox requires
the signal "Start new counting cycle" from the higher-order
controller. Information on the I/O dialogue can be found in
chapter 3.5. Manual resetting of the counter status is only
possible in the operating mode SELECT, see chapter 6.1.5.
All settings of the Checkbox are to be made in the operating
mode SELECT. Please refer here to the explanations in
chapter 6.1.1 ... 6.2.5.
Festo P.BE-Checkbox-EN en 0103c