Table of Contents
Advertisement
IC-KP2-2HB17-2V1D
Commands
<Triggermode>
<WordAddr>
<WordNum>
<Year>
7.17
Fault/Status messages
Status
Error messages which triggered the identification system
Status
94
: 8 bits
0 (00000000b): Trigger mode off
1 (00000001b): Trigger mode on
2 (00000010b): Trigger mode inverted
: 2 bytes, word start address in the data carrier, range from 0000h to
FFFFh, depending on data carrier type.
: 4 bits, number of words to be read or written, range from 0h to Fh,
depending on data carrier type.
The following applies for IPC03: The word count 0h is used with the
word address 0000h to read the preset data range on the data carrier
("Default Read").
The following applies for IQC33: The word count parameter must be
even-numbered because of the block size of 8 bytes. The word
address then indicates the offset in 8-byte increments.
: 2 bytes ASCII, hexadecimal encoding, 00h ... 63h
Meaning
00h
The command has been executed without error.
FFh
The command is processing.
Meaning
01h
The battery of the read/write tag is weak.
02h
Reserved
03h
Reserved
04h
Incorrect or incomplete command or parameter not in the valid range.
05h
No data carrier in the detection range.
06h
Hardware error, e.g. error during self-test or R/W head defect.
07h
Internal device error.
08h
Reserved
09h
The parameterized tag type is not compatible with the connected
reading head.
0Ah
Several tags in the detection range (UHF).
0Bh
Reserved
0Ch
Reserved
0Dh
Reserved
0Eh
Internal buffer overflow.
0Fh
Reserved
Advertisement
Table of Contents
