Legend - Pepperl+Fuchs IC-KP2-2HB17-2V1D Manual

IC-KP2-2HB17-2V1D
Commands
7.16

Legend

<BatteryConditon 1> : 1 byte, first digit of battery status (percentage, decimal, ASCII
<BatteryConditon 2> : 1 byte, second digit of battery status (percentage, decimal, ASCII
<BatteryConditon 3> : 1 byte, third digit of battery status (percentage, decimal, ASCII
<ByteNum>
<Channel>
<ConfAddr>
<Data>
<F>
<Fill Sign>
<FixLen>
<FixType>
<IDCode>
<Identchannel>
<Length>
<Month>
<P>
<ParamTyp>
<PSW>
<ReplyCounter>
<Sensorchannel>
<Status>
<SystemCode>
<T>
<TagType>
<TelegramLenH>
<TelegramLenL>
encoded). 30h, 31h
encoded). 30h, 39h
encoded). 30h, 39h
: 4 bits, length of <IDCode>;
System MV: 4 characters (04h)
System IQ: 8 characters (08h)
: 3 bits, channel of the read/write head
Channel 1 (001b), channel 2 (010b),
all channels (111b)
: 1 ASCII character, word starting address in configuration
range of data carrier. The following applies for IPC03:
01h = Protection Word
02h = Control Word
: <WordNum> times 4 bytes. When communicating a word,
the highest value byte is transferred first and the lowest
value byte, or bytes, last.
: 1 bit, multiplex mode, 0 (0b): Mode off, 1 (1b): Mode on
: 1 ASCII character
: 4 bits, length of the read only code in bytes,
: 2 ASCII characters, for example: '02' for IPC02
: 4 bytes, 6 bytes or 8 bytes (depending on the data carrier type)
: 3 bits, channel of the read/write head
0(0000b), 1 (001b), 2 (010b), all channels (111b)
(but not <Sensorchannel> in trigger mode)
: 2 ASCII characters = number of data bytes
hex
When writing the UII segment + 1:
Range "03", "05", "07" ... (read)
"00" (write)
: 2 bytes ASCII, hexadecimal encoding, 01 ... 0C (01=January,
0C=December)
: 1 bit, password mode, 0 (0b): Mode off, 1 (1b): Mode on
: Parameter type, 2 ASCII characters
: 4 bytes HEX, password
: 1 byte, increases by 1 after each response and confirmation. The reply
counter starts from 0 after the system is switched on. When the
maximum value is reached, the counter skips the value 0 (from 255 to
1).
: 3 bits, channel 1 (001b) or 2 (010b)
: 1 byte (see chapter 7.17)
: = "U"
: 1 bit, toggle bit
: 2 ASCII characters, for example: '02' for IPC02
: 1 byte, high byte of the 16-bit telegram = (N+1) div 256
: 1 byte, low byte of the 16-bit telegram = (N+1) mod 256
93