Installation; Device Connection; Power Supply; Read/Write Head And Trigger Sensors - Pepperl+Fuchs IC-KP2-2HB17-2V1D Manual

IC-KP2-2HB17-2V1D

Installation

5.3 Installation
If you would like to the mount the IDENTControl Compact to a DIN rail, we recommend using
mounting accessory ICZ-MH05-SACB-8.
Note!
The rotary switch used to select the device address is located on the underside of the
IDENTControl Compact. This rotary switch is no longer accessible once the IDENTControl
Compact is installed.
Set the rotary switch before mounting the IDENTControl Compact (see chapter 6.4).
5.4

Device connection

Electrical connection using plug connectors makes installation simple.
5.4.1

Power Supply

Connect the power supply using an M12 connector. A plug with the following pin assignment is
located on the enclosure:
4
1
2
1 + 24 V
2 NC
3 GND
4 NC
Compatible connecting cable see chapter 4.2.2.
5.4.2

Read/Write Head and Trigger Sensors

You can connect a maximum of two read/write heads (125 kHz or 13.56 MHz) or read/write
heads with electromagnetic coupling (UHF with 868 MHz) to the IDENTControl Compact.
You can connect a trigger sensor, instead of a read/write head, to sockets 1 and 2. You can
assign the trigger sensor to a read/write head. The trigger sensor must be PNP.
2
1
4
For details of compatible read/write heads, see chapter 4.1.1 and of compatible connecting
cables, see chapter 4.2.1.
Connecting read/write heads
Connect the read/write heads or the trigger sensor with compatible connecting cable to the top
of the housing via the M12 connector.
3
1 +
2 A
3 -
3
4 B
5
5
trigger switch
+
signal
-
17