Table of Contents
Advertisement
VERSION 07/2009
OPERATING MANUAL
7.1.2
60L CONTAINER VERSION
EP G
P_01137
4
6
7
8
8
P_01141
ORDER NUMBER DOC 2305835
17
SPR INT
5
1
3
2
P_01140
9
10
Procedure:
1. Release the trigger on the spray gun.
The high-voltage and the powder feed are
●
deactivated.
2. Remove the injector 1 from the holder 2.
3. Guide the gun into the spray booth and start the
purge function by pressing the "rinse" button 17.
The injector and hoses are purged.
4. Switch off the control unit.
5. Release the outer nut on powder feed hose 3 and
disconnect powder feed hose 3 from injector 1.
6. Disconnect the red feed air hose 4 from the injector
1.
7. Disconnect the blue dosage air hose 5 from the
injector 1.
8. Check the injector for wear and replace worn parts.
The wear and spare parts can be found in the
Operating manual of the powder injector.
9. Loosen the exhaust air hose 6 from the connection
7 of the powder container 8.
10. Pull the black fl uid air hose 9 off the powder
container 8.
11. Loosen the grounding cable 10 from the powder
container 8.
12. Lift the powder container off from the equipment
trolley for cleaning.
13. Open the lid of the powder container to empty the
powder container and thoroughly blow out the
powder container.
14. Completely remove all residual powder from the
suction system.
15. Pay special attention when cleaning the fl uid base,
check it for blockage or damage and replace it if
necessary. The wear and spare parts can be found in
Chapter "Spare parts" in this Operating manual.
Prima
Sprint.
65
Advertisement
Table of Contents
