Coating Programs - WAGNER Prima Sprint Airfluid Translation Of The Original Operating Manual

VERSION 07/2009
OPERATING MANUAL
6.3

COATING PROGRAMS

Programs help to avoid having to make tedious setting adjustments, whenever the powder
or the workpiece is changed. All relevant parameters for coating a workpiece are collected
and saved under a program number.
These can be called up again as required using the program buttons.
With the EPG Sprint a program comprises the following parameters.
Overall air quantity (feed and dosage air quantity) [m³/h]
Powder quantity
Atomizing air/Tribo air
High-voltage
Current limiting
U/I characteristics
The EPG Sprint control unit has 50 pre-defined programs. 4 of these can be selected
directly using buttons 5-8 and the remaining 46 by pressing button 25 above the
rotary controller 24. All programs can be adapted and stored by the user to suit individual
requirements.
5
6
2x
2x
7
8
25
P_01115
Programs 5 to 50 are selected indirectly. The "additional programs" button 25 must be
pressed fi rst. The yellow "additional programs" LED then lights up and the LED display
indicates the current program number. The required program can be set by turning the
universal rotary controller.
ORDER NUMBER DOC 2305835
[%]
[m³/h]
[kV]
[µA]
[standard, medium, soft]
Program 1 "surface parts": High powder quantity, high powder charging.
Program 2 "second-coating": Small powder quantity, low powder
charging.
Program 3 "profi les": Medium powder quantity, low powder charging.
Program 4 "double click function": Individual setting, activated by a
double click on the manual gun.
Programs no. 5 to 50: Can be selected with the rotary controller after
pressing the button.
Prima Sprint.
41