Fluid Container Setup - WAGNER WideShot Owner's Manual

1. Press the Lock-N-Go™ buttons on both sides of the
sprayer with one hand, grab the cup with your other hand,
and slide the spray cartridge out.
3. Fill the container with the material to be used.
5. Insert the suction set into the intake opening.
7. Take cartridge and slide the rear of the piston into the spray gun. Make sure the pegs (e) on the cartridge line up with the
guides (f) at the bottom of the sprayer. Press cartridge up until it locks into place.

Fluid Container Setup

5
2. Remove the material container from the pump housing by
turning the pump housing locking ring counterclockwise.
4. Place a few drops of household oil down the intake (a)
and return openings (b) in the pump housing.
(a) (b)
6. Line up the tab (c) on the pump housing with the notch
(d) on the material container. Twist the pump ring to
thread the cup onto the pump. Plug in the sprayer.
(c)
(e)
(d)
(f)
English