Interrupting The Coating Process; Airfluid Version - WAGNER Sprint 60 L XE Operating Manual

VERSION 05/2017
OPERATING MANUAL
7.4

INTERRUPTING THE COATING PROCESS

7.4.1 AIRFLUID VERSION

NOTICE
Powder residues and sticking fl uid disk!
Equipment damage and danger of blockage.
Before the control unit is deactivated, the feed unit must be pulled out of the powder
tank.
At every work interruption, blow through the spray gun and the powder feed
components and clean from any powder residues.
50
60
40
m /h 3
Ø
30
Tri
3.0
5.5
12
1.5
4.5
11
20
0.5
3.5
10
9
0.3
2.5
8
10
0.1
2.0
100 %
0 %
P_01785
P_1789
ORDER NUMBER DOC 2354920
70
80
90
17
SP RI N T X
EPG
H
Procedure:
1. Release the trigger on the spray gun.
The high voltage and the powder feed are
deactivated.
2. Lift the feed unit up, underneath the injector,
and lift it out of the tank until retaining clamp
(H) swivels downwards.
3. Lower the feed system into the parking position
and swivel it to the right side so that no more
powder is forwarded.
4. Hold the gun in the spray booth and start the
fl ush function by pressing the "Flush" button (17).
The injector and hoses are fl ushed.
5. Now the control unit can be switched off .
SPRINT XE
43