Safety; Symbols Used; Warnings - MICRO-EPSILON surfaceCONTROL SC2500 Operating Instructions Manual

Safety

1. Safety
System operation assumes knowledge of the operating instructions.
1.1

Symbols Used

The following symbols are used in these operating instructions:
Indicates a hazardous situation which, if not avoided, may result in minor or moderate injury.
Indicates a situation that may result in property damage if not avoided.
Indicates a user action.
i
Indicates a tip for users.
Measurement
Indicates hardware or a software button/menu.
1.2

Warnings

Do not look directly into the light source of the sensor.
> Risk of injury, damage to the eyes and skin
Connect the power supply and the display/output device according to the safety regulations for
electrical equipment.
> Risk of injury
> Damage to or destruction of the sensor
Avoid shocks and impacts to the sensor and the controller.
> Damage to or destruction of the sensor and/or the controller
The supply voltage must not exceed the specified limits.
> Damage to or destruction of the sensor
Avoid constant exposure of the sensor to dust or splashes of water by taking suitable measures
such as blowing off or using a protective housing.
> Damage to or destruction of the sensor
Do not touch the protective windows. Remove any fingerprints immediately using pure alcohol and
a clean cotton cloth without leaving any streaks.
> Failure of the measuring device
Protect the cables against damage.
> Failure of the measuring device
The sensor housing may only be opened by authorized persons.
> Damage to or destruction of the sensor
Only plug in or disconnect devices when disconnected from the power supply.
surfaceCONTROL 3D SC2500 / SC2510 Page 5