Safety; Symbols Used; Warnings - MICRO-EPSILON surfaceCONTROL 2500 Operating Instructions Manual

Safety

CAUTION
surfaceCONTROL 2500
1. Safety
System operation assumes knowledge of the operating instructions.
1.1

Symbols Used

The following symbols are used in these operating instructions:
Indicates a hazardous situation which, if not avoided, may result in
CAUTION
minor or moderate injury.
Indicates a situation that may result in property damage if not
avoided.
Indicates a user action.
i
Indicates a tip for users.
Measure
Indicates hardware or a software button/menu.
1.2

Warnings

Do not look directly into the light source of the sensor.
> Risk of injury, damage to the eyes and skin
Connect the power supply and the display/output device according to the safety regula-
tions for electrical equipment.
> Risk of injury
> Damage to or destruction of the sensor
The supply voltage must not exceed the specified limits.
> Risk of injury
> Damage to or destruction of the sensor
Avoid shocks and impacts to the sensor.
> Damage to or destruction of the sensor
The air inlets and outlets of the sensor must be kept clear and must not be covered
> Damage to or destruction of the sensor
Do not touch the lenses with your fingers. Remove any fingerprints immediately with
pure alcohol and a clean cotton cloth without streaks.
> Damage to or destruction of the sensor
Never kink the cables and do not bend in small radii.
> Damage to or destruction of the cable; failure of the sensor
Protect the cables against damage
> Failure of the sensor
Avoid continuous exposure to splashes of water on the sensor.
> Damage to or destruction of the sensor
The sensor housing may only be opened by authorized persons.
> Damage to or destruction of the sensor
Only plug in or disconnect attached devices when disconnected from the power supply.
Page 5