Maintenance; Systemgard Lubrication Analysis Program - Case 845B VHP Operator's Manual

CHAPTER 6 – LUBRICATION / FILTERS / FLUIDS

MAINTENANCE

General
Always check oil level and drain or fill all the reservoirs with the engine off and machine on a flat ground.
The intervals specified here refer to normal operating conditions. During the initial period of use (run-in) and under
severe working conditions, the servicing intervals need to be shortened.
Drain the engine oil immediately after shutting off the engine while the oil is warm and flows more easily. This will also
assist the discharge of impurities.
After refilling system the oil should be checked only after engine has been run at low idle for a few minutes. This proce-
dure insures that the oil cooler, filters, lines, etc., are completely full before the oil level check is made.
MAINTENANCE AND LUBRICATION CHART DECAL
Peças Plásticas e em Resina
Evite utilizar gasolina, querosene, thinner, etc. para limpar janelas plásticas de inspeção, console, painel de instrumen-
tos, mostradores, indicadores etc. Use SOMENTE água e sabão neutro e um pano macio para limpar estas peças.
A utilização de gasolina, querosene, thinner etc. irá causar descoloração, rachaduras ou deformação da peça que for
submetida a tais produtos.

SYSTEMGARD LUbRICATION ANALYSIS PROGRAM

Ask your dealer about our lubricant analysis program,
Systemgard. Through this service, your lubricants are
tested in an independent laboratory. You simply remove
a sample of lubricant from your machine and send the
sample to the independent Systemgard laboratory.
After the sample is processed, the laboratory will report
back to you and guide you with maintenance require-
ments.
Systemgard can help support your equipment up time and
provide you with a service that can pay back dividends
when you trade for another piece of CASE equipment.
6-4