Case 845B VHP Operator's Manual page 48

Graders
Hide thumbs Also See for 845B VHP:
Table of Contents

Advertisement

6. INSTRUMENT PANEL CLUSTER ASSEMbLY
C
b
A
Cluster Assembly
When the ignition key is turned to the ON position the cluster assembly will check each monitored system. All LED's
(Light Emission Diodes) will turn on, and the warning alarm will sound for three seconds. At the end of this checking all
monitored systems will return to normal functions. The existence of any open circuit between a sensor and the cluster
assembly will cause the LED's flashing, and the warning alarm will sound for 5 seconds.
IMPORTANT: If the stop main indicator light (on the instrument panel) turns on and the warning alarm
sounds continuously during operation, stop the machine and shut-off the engine immediately and identify
the cause.
A. WARNING LIGHTS AND STEERING DIRECTION
INDICATOR LIGHTS
The green indicator light will flash when you
signal a direction or when you turn-on the war-
ning lights.
b. bRAKE PRESSURE GAUGE
This indicator light turns on when the brake
system pressure is too low. The warning alarm
will sound continuously and the stop main indi-
cator light will be red.
NOTE: Stop the machine, and correct the problem.
C.
INDICATOR LIGHT
This indicator light will turn-on when the lights
will be SWITCHED-ON.
D. STEERING AUXILIARY INDICATOR (If EqUIPPED)
This indicator light turns on when the steering
system main pressure is too low. The warning
alarm will sound continuously and the stop
main indicator light will be red.
NOTE: In this situation, stop the machine immediately
and contact your dealer.
3-8
CHAPTER 3 – INSTRUMENTS AND CONTROLS
G
E. PARKING bRAKE INDICATOR LIGHT
This indicator light will turn-on when the pa-
rking brake is applied. When the parking brake
is applied and the transmission gear-shift lever
is in FORWARD or in REVERSE, the warning
alarm will sound for 3 seconds and the warning
main indicator light will be yellow.
f. ENGINE GRID HEATER INDICATOR LAMP
To start the engine, turn the key switch to the
ON position. The indicator (F) illuminates when
the engine grid heater is operating. Wait until
the indicator light goes OFF before moving the
key switch to the START position to start the
engine. The indicator light may come on again
during cranking and shortly after the engine
starts for post heating of the air. This allows for
smooth running conditions during cold weather
warm up.
G. LOW fUEL LEVEL WARNING INDICATOR LIGHT
This light is on continuously
the fuel reservoir is too low.
f
D
A
when the fuel level in
E

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

865b vhp885b vhp

Table of Contents