Case 845B VHP Operator's Manual page 55

N. LCD MULTI-fUNCTION DISPLAY
LCD MULTI-FUNCTION DISPLAY
The LCD Multi-Function Display (liquid crystal display) is
located at the center of the modular dashboard. On start
up, the console indicator lamps will momentarily flash.
The LCD Multi-Display will flash CASE along with the ma-
chine model. The initial standard driving screen will then
appear. Once operator preferences are set, the screen
will reflect those selections.
NOTE: Upon initial startup, the operator can push the re-
turn / escape key, and the language selection screen will
appear immediately. This allows the operator to make a
language selection without having to use an unknown lan-
guage to scroll through to preferences.
CHAPTER 3 – INSTRUMENTS AND CONTROLS
1
2
3
A
Information will be displayed in three zones on the LCD,
as directed by the operator or machine. In most situations
the operator or technician will be given specific informa-
tion prompts to follow if conditions are not correct.
1. Zone One:
The top section of the LCD display will
show the machine hours, speed, or RPM's. The dis-
play is controlled by machine technology and geared
toward operator preferences. The screen shown is the
default screen.
In the example shown, the machine hours are dis-
played. Machine hours will always be displayed briefly
on start up. After the machine is started, the display will
change to show engine RPM's. When the machine is
moving, this area will change to show speed or RPM's.
The operator can make a preference selection, pro-
gramming the screen to show MPH, km/h, or RPM's.
2. Zone Two:
This center of the display is dedicated to
transmission signals. The example above shows the
transmission control lever in neutral (N), the gear nu-
merically (4th), and the automatic transmission mode
(A) (models equipped with ZF transmission) or Manu-
al (M). Fault codes will be displayed in Zone 2. As an
example this section may list transmission fault codes.
If the transmission is not operating correctly the dis-
play may show:
C – Substitute clutch
L – Safety Mode
Limp Home (845B / 865B / 885B models
with transmission ZF) or
Come Home (845B / 865B / 885B models
with transmission FUNK)
For additional information,
refer to pages 8-4
S – Transmission shutdown
U – Transmission control unit shutdown
3. Zone Three: The lower section of the LCD display is
divided in two sections. The left hand section indicates
if the gearbox is clutched or unclutched. It also indica-
tes the power mode Max/Std/Auto/Eco. The example
above displays Auto. The right hand section (B) dis-
plays the clock. Time can be set in either 12 or 24 hour
increments.
and 8-5
b
3-15