Case 845B VHP Operator's Manual page 61

Options Menu
Use the arrow keys to choose the options menu. Press
the confirm key, and the options sub-menu will appear.
The options menu will allow the operator to choose op-
tions for the fan, grid heater, auto idle, etc.
FaN auTo – oNly 885B MoDElS
WITH Zf TRANSMISSION
The fan can be set to run in automatic or manual mode. In
the manual mode the fan will run at maximum speed. The
Automatic is the more common or preferred setting. It will
switch between high speed and low speed as conditions
require, depending on coolant temperature, turbocharger
air, transmission fluid, and hydraulic oil.
CHAPTER 3 – INSTRUMENTS AND CONTROLS
RPMS / SPEEDOMETER
These settings allow the operator to show either speed or
RPM's on the main menu when operating the machine. If
travel speed is the desired setting, the operator can choo-
se between MPH or km/h for the display. Highlight the
desired choice, press the confirm key, then escape back
to the main screen to lock the selections into memory.
HARDWARE / SOfTWARE SCREENS
The hardware and software screens cannot be changed
by the operator.
The hardware selection will display the part number, serial
number, ID number and version of the hardware cluster.
The software selection will display the part number, serial
number, ID number and version of the software cluster.
Press the escape key to exit from this field or use the up
arrow key to scroll backwards for another selection from
the select sub-menu.
3-21