Case 845B VHP Operator's Manual page 63

7. INCHING PEDAL
(ONLY 845b / 865b / 885b MODELS
WITH fUNK TRANSMISSION)
Serves to provide the operator the ability to move a loa-
ded machine with smooth and exact speed control (the
inching pedal must not be used continuously more than
25 meters for speed and traction control).
Pressing totally the inching control pedal activates the
switch that puts the transmission in neutral position. As
soon as the inching pedal is smoothly released to the
totally released position (upwards), the clutch assembly
pressure (for the gear in use), is gradually increased. Allo-
wing this way the machine to start moving.
1
1. INCHING PEDAL
(ONLY 845B / 865B / 885B MODELS
WITH FUNK TRANSMISSION)
2. CONSOLE TILT PEDAL
3. BRAKE PEDAL
4. ACCELERATOR / DECELERATOR PEDAL
CHAPTER 3 – INSTRUMENTS AND CONTROLS
4
3
2
8. CONSOLE TILT PEDAL
CONSOLE TILT PEDAL
The console may be adjusted to improve operator comfort.
Push the pedal to free the console. Position the console
in the desired position and then release the pedal to lock
the console again.
9. bRAKE PEDAL
This pedal actuates the service brakes. To stop the motor-
grader press down on brake pedal.
NOTE: Do not descend steep slope using only the service
brake. Reduce the speed and apply the brakes. Select
an appropriate speed, allowing total machine control. This
will avoid brake heating, and will increase the life of the
components.
10. ACCELERATOR / DECELERATOR PEDAL
The accelerator / decelerator pedal is connected to the
engine throttle controls. To accelerate the engine, press
down on the front part of the pedal and to decelerate
press down on the rear of the pedal. When the pedal is
released, the engine speed will return to the hand throttle
setting.
3-23