Case 845B VHP Operator's Manual page 28

Starting
Do not run engine in closed areas without proper ventila-
tion systems for the exhaust gases.
Never expose your head, body, feet, hands and fingers
close to rotating fans or belts .
Engine
Turn the expansion tank cap slowly to relieve system
pressure before removing it. If any coolant is needed, add
only to a cold or slow running engine.
Do not refuel machine with the engine running, particular-
ly if it is too hot, so as to prevent fire.
Never attempt to check or adjust belt tensions with the
engine running.
Avoid running the engine with air intakes open without the
protective guards.
If for any technical reasons, this is not possible, fit pro-
per protections over these openings prior to servicing or
operation.
Electrical System
If you have to jump start, remember cable ends must be
connected as follows: (+) to (+) and (-) to (-). Avoid short-
circuits. Follow carefully the instructions in this Manual.
Before any intervention in the electric system, make sure
the ignition key is placed to the OFF position.
The fumes released by the battery are highly flammable.
While recharging, leave batteries uncovered for better
ventilation. Never check battery charge by short-circuiting
the battery terminals. Do not smoke near batteries to pre-
vent explosions.
Prior to carrying out any servicing, check for fuel or bat-
tery electrolyte leaks. Eliminate these leaks prior to pro-
ceeding with the work.
Do not charge batteries in closed areas. Check for proper
ventilation to prevent possible inadvertent explosion cau-
sed by fumes buildup from the charging operation.
2-12
CHAPTER 2 – SAFETY / DECALS / HAND SIGNALS
Hydraulic System
Fluid gushing from a hole can be invisible to the eye but
have sufficient force to penetrate the skin causing serious
injuries. Under these circumstances, if you have to locate
leaks, use a piece of cardboard or wood.
Never use your bare hands: if the fluid penetrates your
skin, see a doctor immediately. Lack of quick medical at-
tention may lead to serious complications and skin dise-
ase.
Relieve internal system pressure prior to removing any
caps, plugs, etc. (See applicable instructions).
When checking system pressures, use appropriate mea-
suring instruments.
Implements
Keep your head, body, feet and hands away from the rai-
sed implements. Use supports provided as a safety me-
asure, prior to proceeding to servicing and repair opera-
tions. Use proper safety elements.
If you must operate an attachment using the hydraulic
machine control system, remember that this operation
must be carried out only from the operator's seat position.
The operator is responsible for any non-authorized per-
sons allowed into the cab.
Ensure no other persons are within the machine's radius
of operation.
Give warnings using the horn or using your own voice. Lift
the attachment slowly.
Do not use the machine for transporting loose objects,
unless suitable means are provided for this purpose.
When leaving the operator's cab, lower the attachment to
the ground.
Prior to carrying out any servicing or repair operation with
raised attachments, these must be supported on stable
supports.
It is recommended that you carry a FIRST AID kit in the
machine.