Case 845B VHP Operator's Manual page 51

J
J. TRANSMISSION fLUID TEMPERATURE GAUGE
This indicator shows the transmission fluid temperature. The normal operation temperature is within the
green band. When the transmission fluid temperature raises, the indicator will pass to the yellow band,
the warning alarm will be actuated for three seconds, and the warning main indicator will change to yellow.
When the temperature continues raising, the indicator changes to the red band, the warning alarm will sound
continuously and the stop main indicator will be red. The machine MUST NOT be operated when the tem-
perature is in the red band.
Gauge Indication
20°C and below
(68°F and below)
20°C to 120°C
(68°C to 248°F)
120°C to 125°C
(248°F to 257°F)
(See the note below)
125°C and above
(257°F and above) temperature is very high.
NOTE: In order to avoid damages to the transmission, stop the machine, shift the transmission in NEUTRAL position,
and run the engine at maximum throttle until transmission is cooled. If the transmission fluid temperature does not re-
turn to normal operation temperature, run the engine at idle speed and check the fluid level in the transmission. Correct
the defect before continuing the operation of the machine.
CHAPTER 3 – INSTRUMENTS AND CONTROLS
TRANSMISSION OIL TEMPERATURE GAUGE
Condition Master Indicator
Transmission oil
temperature is very low.
Transmission oil
temperature is normal.
Transmission oil
temperature is high.
Transmission oil
Gauge Status
Caution (Yellow)
Caution (Yellow)
Stop (Red)
K
Alarm Status
Continuous 3 Seconds
Continuous
Intermittent
Continuous (0,5 sec. ON and
0,2 sec. OFF)
3-11