Engine Cooling System - Case 845B VHP Operator's Manual

Service Specifications
Cooling System Capacity ............................................................................................................ 32,0 liters (8.4 US gal)
Radiator coolant fluid level check ....................................................................................... Every 10 hours of operation
Cooling system drain, flush, and refill interval ........................................... Every 2000 hours of operation or each year
Thermostat
Starts to open ............................................................................................................................................. 82°C (180°F)
Completely open ......................................................................................................................................... 95°C (202°F)
Expansion tank cap ................................................................................................................. 103,4 kPa, 1 bar (15 psi)
Coolant Mixture
A mixture of 50% AKCELA PREMIUM ANTI FREEZE and
50% water must be used in this machine. This mixture is
used if the lowest ambient temperature is above -37°C
(-34°F). If the ambient temperature is lower, adjust the
mixture to 60% AKCELA PREMIUM ANTI FREEZE and
40% water. It is recommended that AKCELA PREMIUM
ANTI FREEZE and water be used in your machine all
year.
NOTE: After you fill the cooling system, mix the AKCELA
PREMIUM ANTI FREEZE and water completely by run-
ning the engine at operating temperature for approxima-
tely five minutes. This procedure must be done when the
machine is in temperatures below 0°C (32°F).
WARNING: Hot coolant can spray out if ex-
pansion tank cap is removed. To remove ex-
pansion tank cap: Let system cool, turn to first
notch, then wait until all pressure is released.
Scalding can result from fast removal of ex-
pansion tank cap. Check and service engine
cooling system according to maintenance ins-
tructions.
6-22
CHAPTER 6 – LUBRICATION / FILTERS / FLUIDS

ENGINE COOLING SYSTEM

2
1. EXPANSION TANK CAP
2. COOLING WATER LEVEL GAUGE
3. REGISTER FOR AIR BLEED
3
1