Case 845B VHP Operator's Manual page 56

Navigating Through the LCD Multi-function Display Screens
KEY PAD
A
b
The key pad is located on the console just below the ste-
ering wheel. Use this key pad to move from one screen to
another, choose various selections, monitor the machine
functions, and retrieve information.
All selections made with the computerized technology of
the LCD screen are essentially programmed in the same
manner.
When using the screen, use the arrow keys (C and D) to
scroll to the desired selection, highlight that selection and
press the confirm / enter key (B).
Follow any screen prompts when given and use the con-
firm key to enter the selection. Use the escape key (A) to
return to the main menu. This will lock the chosen selec-
tion into memory.
All functions can be accessed in the same basic manner.
A. Escape key: Use this key to exit and return to the
driving screen. This key can be used anytime to
start over and begin again or to exit a field. It can
also be used to electronically check fault codes.
b. Enter / Confirm key:
lections: After selections have been highlighted,
use the enter / confirm key to choose selections.
C. Up arrow key: Use this key to scroll up to selec-
tions.
D. Down arrow key:
selections.
NOTE: Arrows on the screen will indicate if selections are
up or down from the current selection.
3-16
CHAPTER 3 – INSTRUMENTS AND CONTROLS
C
D
Use this key to confirm se-
Use this key to scroll down to
USING THE ARROW KEYS
At any time during operation or with the key switch on,
the operator may scroll through three information scre-
ens and two trip screens by using the arrow keys. These
five screens are in a circular loop and may be accessed
by pressing the up or down key. The following sequence
shown uses the down key only.
NOTE: Pressing the escape key will return the LCD back
to the normal driving screen. In order to lock the changes
into memory, the operator must press the confirm key, then
use the escape key to return to the main screen. Turning
the machine off will also lock the settings into memory.
From the driving screen, push the down arrow, as shown.