Case 845B VHP Operator's Manual page 146

Zf Transmission fluid Change
845b / 865b / 885b MODELS
WITH Zf TRANSMISSION
Each 1000 hours
Run engine until transmission fluid reaches operating
temperature. Park grader on a level surface, apply parking
brake, lower moldboard to ground and shut-off engine.
Remove the drain plug and drain the fluid in a container of
at least 25 liters (6.6 U.S. Gallons) capacity.
Reinstall the plug. At this time, the transmission fluid filter
must be replaced too.
Fill the system with the specified fluid, until the specified
level. Run the engine to heat the fluid and complete the
fluid level, if necessary.
WARNING: Never use gasoline, solvent or
other flammable fluids to clean parts. Use au-
thorized commercial, nonflammable, nontoxic
solvents.
fUNK Transmission fluid Change and Screen Cleaning
845b / 865b / 885b MODELS
WITH fUNK TRANSMISSION
Each 1000 hours
Run engine until transmission fluid reaches operating
temperature. Park grader on a level surface, apply parking
brake, lower moldboard to ground and shut-off engine.
Remove the drain plug and drain the fluid in a container of
at least 25 liters (6.6 U.S. Gallons) capacity.
Clean the screen thoroughly. Reinstall the screen and the
drain plug. At this time, the transmission fluid filter must
be replaced too.
Fill the system with the specified fluid, until the specified
level. Run the engine to heat the fluid and complete the
fluid level, if necessary.
WARNING: Never use gasoline, solvent or
other flammable fluids to clean parts. Use au-
thorized commercial, nonflammable, nontoxic
solvents.
6-36
CHAPTER 6 – LUBRICATION / FILTERS / FLUIDS
1. DRAIN PLUG
1. DRAIN PLUG
2. SCREEN
1
1
2