Case 845B VHP Operator's Manual page 92

10. Lubricate all points where lube fittings are rovided.
Refer to lubrication and service guide for instructions
and location.
11. Check tire inflation pressure.
WARNING: Do not inflate tires with flamma-
ble gases or air from systems utilizing alcohol
injectors. Explosion and personal injury may
be resulted.
12. The cooling system of the unit is filled at the factory
with a 50/50 mixture of water and AKCELA PREMIUM
ANTI FREEZE (1060077) for protection to -34ºF
(-37ºC). It is not necessary to drain this solution before
placing the machine in service.
IMPORTANT: Do not use hands to search for pressure
leaks. Fluid escaping under high pressure can penetrate
skin causing serious injury.
IMPORTANT: Do not run the engine in closed areas wi-
thout proper ventilation to remove poison exhaust gases.
Warn all people who may be working around your machi-
ne before starting the engine.
Sound horn before starting or operating the machine.
Never leave the machine unattended with the engine run-
ning.
4-2
CHAPTER 4 – OPERATING INSTRUCTIONS
13. Start engine. Check all instruments and gauges for
normal indication. Operate controls and check for nor-
mal operation. Stop the engine and check the hoses,
piping and gaskets for possible oil leaks.
NOTE: To start the engine the parking brake must be ap-
plied and the gearshift selector lever in "NEUTRAL" po-
sition.
IMPORTANT: Remove the articulation lock-pin before
operating the machine.
ARTICULATION LOCK PIN (STORAGE POSITION)
SHALL BE USED ONLY FOR MACHINE TRANSPORT