Troubleshooting - Sav 531.42 Operating Instructions Manual

SAV 531.42

9 TROUBLESHOOTING

9. TROUBLESHOOTING
The safety information from the section 2 "Safety must be observed.
DANGER!
DANGER!
Potential causes for the malfunctions and recommended remedial measures:
Description of the fault/mal-
function
Corrosion of the functional
surface
Corrosion on the lifting eye
Minor damage to the function-
al surface (dents, scratches)
Severely damaged or worn
contact surfaces on more than
10 % of the area
Damage to the lifting eye
Damage to the load-bearing
components
Version 1.0
Hazard from malfunction!
Incorrect troubleshooting and installation of the lifting magnet can cause a
malfunction of the magnet.
Loads can fall down and cause serious injuries and even death.
Have troubleshooting carried out only by qualified personnel.
■
The lifting magnet has to be set down securely or attached to the load.
■
Check after troubleshooting and installation!
If it is not possible to restore the function of the lifting magnet on your
■
own, the lifting magnet must be taken out of service. Contact customer
service at SAV GmbH and provide a description of the malfunction.
Risk of crushing!
There is a risk of crushing limbs from tipping over or falling of the lifting
magnet due to incorrect installation and removal of the magnetic magnets.
Secure the lifting magnet against falling or tipping over.
■
To lift the lifting magnets, always use safety hooks that are designed for
■
the weight of the lifting magnets, so that the lifting eye cannot slip from
the hook.
Have troubleshooting carried out only by qualified personnel.
■
Possible causes of the
fault/malfunction
Ambient humidity
Abrasion
Dirt between the load and
the functional surface
Impact, fall
Dirt, impact, fall
Impact, pressing on.
Excessive wear on the eye
cross-section on more than
10 %
Impact, fall, pressing-on
[
105
Possible remedial measures
Remove corrosion. Preserve surfaces
before storage.
Remove corrosion. Apply protective
coating.
Always clean the Sweep a grinding
contact surface stone across it.
before attaching Repair larger
the lifting magnet. notches with a
file.
Avoid rough
actions.
Mill across the functional surfaces.
Replace the damaged lifting eye.
Take the lifting magnet out of service
and contact customer service at SAV
GmbH.
]
To be carried out by
Operator
Maintenance engineer,
mechanic
Operator
Maintenance engineer,
specialist mechanic
Maintenance engineer,
mechanic
Maintenance engineer,
specialist mechanic
EN