Table of Contents
Advertisement
Operating the projector
Control panel
1. POWER
Switches the projector on and off (STANDBY).
2. INPUT
Displays the input selection menu.
3. AUTO SYNC
Re-synchronises with the current input signal.
4. ASPECT
Changes the aspect ratio.
5. CENTER LENS
Centers the lens.
6. PIC MUTE
Shows and hides the projected image. When muted,
the light source is completely switched off and the
screen is blank.
7. MENU
Displays and exits the OSD.
8. Arrow buttons & ENTER
Press an arrow button to open the keystone menu.
Use the arrow buttons to adjust vertical and horizontal
keystone. After opening the OSD, use the arrow
buttons to highlight menu entries. Press ENTER to
open or execute the highlighted menu entry.
9. EXIT
Exits the current OSD page and enters the level
above.
10. LENS SHIFT
Arrow buttons move the lens in the specified direction.
11. FOCUS
Plus and minus buttons move the focus in and out.
12. ZOOM
Plus and minus buttons zoom in and out.
Installation & QuickStart Guide
Operating the projector
1
2
3
4
AUTO
POWER
INPUT
ASPECT
SYNC
7
8
9
Control Panel
5
6
CENTER
PIC MUTE
LENS
10
11
12
Digital Projection E-Vision Laser 15000 Series
Notes
See Connecting the power supply
on the previous page.
Use only the power cable
provided.
Ensure that the power outlet
includes a ground connection
as this equipment MUST be
earthed.
Handle the power cable
carefully and avoid sharp
bends. Do not use a damaged
power cable.
See Using the menus on page 48
for full details of how to use the
controls and the menu system.
Rev B April 2021
page 27
Advertisement
Table of Contents
