If you are using a computer graphics card or another source that obeys the EDID protocol, the source will automatically configure itself to suit the capability of the

projector.

Otherwise refer to the documentation supplied with the source to manually set the resolution to the DMD™ resolution of the projector or the nearest suitable

setting. Switch off the source, connect to the projector, then switch the source back on again.

Using DisplayPort / HDMI / HDBaseT switchers with the projector

When using a DisplayPort/HDMI/HDBaseT source switcher with the projector, it is important to set the switcher so that it passes the projector EDID through to the

source devices.

If this is not done, the projector may not be able to lock to the source or display the source correctly as its video output timings may not be compatible with those of

the projector. Sometimes this is called transparent, pass-through or clone mode. See your switcher's manual for information on how to set this mode.

1. Sources

2. Switcher

3. Projector

Connection Guide

Signal inputs

EDID

The EDIDs in the switcher should be the same as the one in the projector.

Digital Projection E-Vision Laser 15000 Series

EDID

Notes

Rev B April 2021