Control Connections - Digital Projection E-Vision Laser 15000 Series Installation & Quick Start Manual

Digital Projection E-Vision Laser 15000 Series

Control connections

1. Trigger
Trigger outputs are defined in the Setup menu. Each
ouput can be triggered by one of the following
conditions:
Screen trigger. A trigger output can be used
l
to control an electrically operated screen. The
screen will be automatically deployed when
the projector starts up and retracted when the
projector shuts down.
Aspect ratio trigger. A trigger output can be
l
used to control screen shuttering for different
aspect ratios.
RS232 trigger. A trigger output can be used
l
to control the screen or screen shuttering on
receipt of an RS232 command.
2. RS232
All of the projector's features can be controlled via a serial connection, using commands described in the Protocol Guide. Use a crossover cable to
connect directly to a computer.
3. Wired Remote
The remote control can be connected using a standard 3.5 mm mini jack cable (tip-ring-sleeve, or TRS).
4. HDBaseT/LAN
The projector's features can be controlled via a HDBase-T or LAN connection, using Digital Projection's Projector Controller application or a terminal-
emulation program.
Rev B April 2021
page 44
Control connections
1
2
USB RS-232 V H B/Pb
TRIGGER
WIRED
REMOTE HDBaseT/LAN HDMI 1 DVI-D
3 4
G/Y R/Pr VGA MONITOR OUT
DISPLAYPORT IN SDI OUT HDMI II 3D SYNC
Notes
Only one remote connection
(RS232 or LAN) should be used at
any one time.
With a LAN connection the
projector can serve a web page
OUT
offering status and projector
controls.
IN
Projector Controller is available
for download, free of charge, from
the Digital Projection website.
Connection Guide