Table of Contents
Advertisement
Digital Projection E-Vision Laser 15000 Series
Selecting an input signal
1. Connect one or more image sources to the projector.
2. Select the input you want to display:
Press one of the input buttons on the remote control.
l
Alternatively, open the On-screen display (OSD) by pressing MENU. Highlight Input from the main menu, press ENTER/OK and then select an
l
input signal using the UP and DOWN arrow buttons. Press ENTER/OK to confirm your choice.
Selecting a test pattern
The following test patterns are available: White, Black, Red, Green, Blue, Checkerboard, White Crosshatch, Red Crosshatch, Green Crosshatch, Blue
Crosshatch, Color Bar, Screen Layout, Off
To display a test pattern:
Press TEST on the remote control.
l
Change the test pattern using the LEFT and RIGHT arrow buttons.
Alternatively, open the OSD by pressing MENU. Highlight Test Patterns from the main menu, then select a test pattern using the LEFT and RIGHT arrow
l
buttons.
After the final test pattern, the projector exits test pattern mode and returns to the main image. To view test patterns again, you need to press TEST again. If you
wish to exit the test patterns before you reach the final one, press TEST or EXIT at any time.
Rev B April 2021
page 34
Operating the projector
Notes
Please refer to the connection
guide for details about connecting a
signal source. See Signal inputs on
page 38
Installation & QuickStart Guide
Advertisement
Table of Contents
