Sensor(S) Dirty - Fujitsu fi-8190 Operator's Manual

Error Code
J2:56
● For the Function Number Display
An alphabetical character and a number for the error code are displayed alternately on the Function Number
Display.
Error Code
J2
If documents remain in the scanner, refer to
If documents are overlapped and fed into the scanner frequently, take measures according to
Documents Are Frequently Fed into the Scanner (page
If the problem still persists, write down the error code, check each item in
Service Provider (page 330)
the contact information in the Contact List if supplied with this product, or refer to the contact information in
the Contact for Inquiries section if provided in Safety Precautions supplied with this product, and then make an
inquiry.

Sensor(s) Dirty

If sensors are dirty, the following is displayed on the operator panel.
● For the LCD
An error code, error details, and a solution for the problem are displayed on the LCD.
Error Code
J8:01
J8:02
J8:04
J8:08
● For the Function Number Display
Error Details and the Solution
J2:56 Error
Multifeed detected (Length)
Press the [Scan/Enter] button. If there is a document that is being fed, it
will be ejected.
Error Details (displayed in the Error Recovery Guide window)
Multifeed detected (Length)
Multifeed detected (Overlap)
When a Paper Jam Occurs (page 246)
314).
and then contact the distributor/dealer where you purchased this product. Refer to
Error Details and the Solution
J8:01 Error
Sensor(s) dirty
Clean the Pick Sensor.
J8:02 Error
Sensor(s) dirty
Clean the Skew Sensor (left).
J8:04 Error
Sensor(s) dirty
Clean the READ-TOP Sensor.
J8:08 Error
Sensor(s) dirty
Clean the Skew Sensor (right).
266
Troubleshooting
to remove the documents.
Overlapped
Before You Contact the Scanner